Tuesday, November 24, 2015

Concerning How To Restore Faded Fiberglass

By Marci Nielsen


Fiberglass has an outer surface made of gel coat. It does not add much value to its structure. Nonetheless, it protects it and makes it look shiny. Additionally, it gives color to the product. Below is a discussion on how to restore faded fiberglass.

Exposure and time usually erode the outer layer. This makes the item look chalky and dull. However, you do not have to worry about this because it is a problem which can be fixed easily. The initial phase is to clean the product. Lukewarm water is preferred. If possible, use some detergent and a sponge. Nevertheless, you ought to don on some gloves to protect your hands.

If mildew is present, bleach will have to be utilized in the cleaning process. Additionally, concentrated cleaning formulation should be used when stubborn stains are present. The surface should be rinsed with clean water so that all the detergent present is washed away. Thereafter, allow the item to dry off. If you are in a hurry, you can dry it manually.

Ensure there are no traces of oil before proceeding. Cleaning alone cannot guarantee this. That is why you need to get more serious oil removers. They include acetone and MEK. Make sure there are several cotton cloths to use in removing the oil. After accomplishing this you can wax the fiberglass. This is an essential step which helps in prolonging the life of the product.

You will have to follow the instructions of your manufacturer carefully. Remember that not all waxes have the same procedure of application. However, you will need a cloth in waxing. Circular motions are encouraged. Wait until the wax is dry to buff the extra. You need a special cloth for this task.

The next step is polishing. This should be done using an abrasive. Fine sandpaper is preferred. It will remove pitted areas. This is not something you can achieve with coating. You should tackle a small section at a time. In addition, the motions have to be circular. Go on until you can see your reflection on the surface. An extra layer of wax should be added after you are done polishing for protection. Some preparations contain wax in the formulation.

Sometimes the product is worn significantly. In such a case, even polishing will not give back its shine. You will have to use a very strong abrasive during the scrubbing. You should remove any remaining wax on the surface before you begin polishing it. It can make the compound appear uneven. While clearing the wax, do not move up and down but rather on a straight line. Toluene or a de-waxing solution should be utilized.

A restorer should be applied last. There are a lot of them meaning you will not have a difficult time shopping for one. They work almost the same as wax. Nonetheless, buffing is recommended after the restorer has being applied. You will be impressed with the results. However, remember that the item will not retain the new look forever. However, it will last for some time if you take care of it well.




About the Author: